Delta RMC151 - Manual (Page 1142)

RMC70/150 and RMCTools User Manual
1 = Slave - Clock is an
input
F144+n:17 73741
+512 x n
E1_08204
+512 x n
DWORD %MD144+n.17 DWORD Read/Write Channel 0 SSI Options
Applies only to SSI
Output and SSI Register
Input modes]
Bit 0-5 - SSI Data Bits
Range: 8-32
Bit 6 - SSI Encoding
0=Binary, 1=Gray Code
Bit 8 - Terminate
Inputs
[Applies to all SSI Output
and SSI Register Input
modes except SSI Output
- Master.]
SSI Register Input -
Standard: Data Inputs
SSI Register Input -
Monitor: Clock/Data
Inputs
SSI Output - Slave: Clock
Inputs
Bit 16-31 - SSI Clock
Rate (kHz)
Specifies the clock rate in
kHz. The actual rate will
be determined by the
available integer divisor
(16500/SSIClockRatekHz-
1). Initial supported
values are 250, 500, and
971, with the default of
250 kHz.
F144+n:18 73743
+512 x n
E1_08206
+512 x n
DINT %MD144+n.18 DINT Read/Write Channel 0 Wire Delay
[Applies only to SSI
Register Input modes]
Time to delay (ns) from
Clock to Data. This value
will be converted to the
nearest time delay that
can be represented with
[1..8] * [0..31] / 33MHz.
F144+n:19 73745
+512 x n
E1_08208
+512 x n
DWORD %MD144+n.19 DWORD Read/Write Channel 0 Source/Dest
[Applies only to SSI
Output and SSI Register
Input modes]
For SSI Output mode,
this is the address of the
register to send out the
SSI Output. Ignored if
Echo is enabled. For SSI
Register Input, this is the
1122 Delta Computer Systems, Inc.