Delta RMC151 - Manual (Page 794)

RMC70/150 and RMCTools User Manual
Command Parameters
# Parameter Description Data Type Range
1 Curve ID Internal:
DINT
External:
REAL
0-50000
2 Master Register
Note: See Specifying a Register
Address below.
REAL _Time or any
other valid
register of
type REAL.
3 Cycles
0 = continuous,
1 = 1 cycle
n = n cycles (up to 16 million)
REAL 0 to 16
million
(0 =
continuous)
4 Options, sum of the following:
Curve Alignment, one of:
Absolute Curve Alignment (+0)
Relative Curve Alignment (+1)
Master Alignment, one of:
Relative Master Alignment (+0)
Absolute Master Alignment (+2)
Endpoint Behavior
For Absolute Master alignment,
one of:
Fault (+0)
Truncate (+4)
Extrapolate (+8)
For Relative Master alignment,
one of:
Standard (+0)
Truncate (+4)
Truncate and End (+8)
Internal:
DINT
External:
REAL
≥ 0, whole
numbers
5 Curve Scale REAL any
6 Curve Offset REAL any
7 Master Scale REAL ≠ 0
8 Master Offset REAL any
9 Status Block (address)
Note: See Specifying a Register
Address below.
REAL Address or
none (0)
Description
This command is identical to the Curve Start (86) command, but with additional advanced
options such as offsetting or scaling the y-axis of the curve, offsetting or scaling the curve
master, choosing absolute or relative curve alignment or master alignment, and the
inclusion of a status block for advanced status information.
Notice that the command parameters do not change the curve itself in the RMC. It only
defines the instance of the curve that is started with this command.
774 Delta Computer Systems, Inc.