Delta RMC151 - Manual (Page 145)

3 Controller Features
Note: This is very tedious to do directly from RMCTools, but you may need to when you are
first trying it.
Part #1:
Variable Data Description
Curve Data
Offset
512 0 Status = 0 -
513 20 Format = 20 -
514 0 Part Offset = 0 -
515 507 Part Length = 507 -
516 2504 Total Length = 2504 -
517 2500 Point Count = 2500 0
518 0 Interpolation Options
= 0
1
519 0 X
0
= 0 2
520 0.1 X interval = 0.1 3
521 Y
0
Y
0
4
522 Y
1
Y
1
5
: : : :
1023 Y
502
Y
502
506
After writing part #1 and issuing the Curve Add command, the user should wait for the
Curve Status at Variable 512 to become 2 (if you are looking in RMCTools, make sure to
look in the Monitor tab of the Variable Table Editor), indicating that the RMC has
completed processing the part.
Part #2
Variable Data Description
Curve Data
Offset
512 0 Status = 0 -
513 20 Format = 20 -
514 507 Part Offset = 507 -
515 507 Part Length = 507 -
516 2504 Total Length = 2504 -
517 Y
503
Y
503
507
: : : :
1023 Y
1009
Y
1009
1013
After writing part #2 and issuing the Curve Add command, the user should wait for the
Curve Status at Variable 512 to become 2 (if you are looking in RMCTools, make sure to
look in the Monitor tab of the Variable Table Editor), indicating that the RMC has
completed processing the part.
Part #3
Variable Data Description
Curve Data
Offset
512 0 Status = 0 -
513 20 Format = 20 -
deltamotion.com 125