Delta RMC151 - Manual (Page 1127)

9 Register Reference
This register
controls whether the
PROFIBUS Station
Address can be
changed over
PROFIBUS by a
Class 2 master.
Notice that
RMCTools can
always change the
station address,
regardless of the
value of this
register. Also,
setting the station
address over
RMCTools will set
this register to zero
(0).
NOTE: Only
RMC150E controllers
with the PROFIBUS
communication
module installed
have this register.
F45:6 23053 D23052 DWORD %MD45.6 DWORD Read Only PROFIBUS
Connection Status
F45:7 23055 D23054 DINT %MD45.7 - - Reserved
F45:8 23057 D23056 DWORD %MD45.8 DWORD Read Only MAC Address (bytes
0-3)
big Endian, (for 00-
50-A0-B1-23-45,
this would be
0x0050A0B1)
F45:9 23059 D23058 DWORD %MD45.9 DWORD Read Only MAC Address (bytes
4-5)
big Endian, in upper
16 bits (for 00-50-
A0-B1-23-45, this
would be
0x23450000)
F45:10 23061 D23060 DWORD %MD45.10 DWORD Read Only Ethernet Status Bits
F45:11 23063 D23062 DWORD %MD45.11 DWORD Read/Write Ethernet
Configuration Bits
F45:12 23065 D23064 DWORD %MD45.12 DWORD Read/Write IP Address
F45:13 23067 D23066 DWORD %MD45.13 DWORD Read/Write Subnet Mask (0=use
standard network
masks)
F45:14 23069 D23068 DWORD %MD45.14 DWORD Read/Write Default Gateway
(0=none)
F45:15 23071 D23070 DWORD %MD45.15 DWORD Read Only DHCP (or BOOTP)
deltamotion.com 1107