Delta RMC151 - Manual (Page 629)

6 Communication
Adding an RMC Analog Display to an InTouch Window
Follow these steps to add the Axis 0 Actual Position to an InTouch window.
Note: These instructions are for InTouch 9.5.
1. On the Special menu, click Access Names, then click Add, and do the following:
a. In the Access box, type an name like "RMC" (without the parentheses).
b. In the Application Name box, type "DASABCIP" (without the parentheses).
c. In the Topic Name box, type the name you entered in the Device Group tab
in the System Management Console. This is "RMC" (without the parentheses).
d. Click OK.
2. On the Special menu, click Tagname Dictionary, then click New, and do the
following:
a. In the Tagname box, type an name like "Axis0ActPos" (without the
parentheses).
b. Click Type and choose I/O REAL, and click OK.
c. Choose Read Only.
d. Click Access name, choose RMC and click Close.
e. In the Item box, type "F8:8" (without the parentheses). This means it is
looking at a register F8:8 in the RMC, which is the Axis 0 Actual Position.
f. Click Save, then click Close.
deltamotion.com 609