Delta RMC151 User Manual
Page 596
RMC70/150 and RMCTools User Manual
3.
If you have an existing EtherNet/IP network that you are adding the RMCs to, then do
the following:
a.
Open your existing Network Configurator file.
b.
Skip to step 5.
4.
If this is a new EtherNet/IP network, then do the following:
a.
From the list of EtherNet/IP Hardware on the left side, drag the appropriate
communications adapter to the network line on the right side.
2.
b.
Right-click on the new node in the diagram, and click Change Node Address.
c.
Enter the new Communication Adapter’s IP address to match the address set up
in the PLC IO Table and click OK.
5.
Install the RMC75/150 EDS files into the Network Configurator.
There are four EDS files available currently available for RMC75 and RMC150
controllers. The most current versions are available for download from Delta’s website
Each EDS file is packaged in a compressed (.zip) file
with its corresponding icon.
EDS File
Product Version
1
Firmware Download Location
rmc75e_v1.eds RMC75E 1.x
2.20-
3.40.x
576
Delta Computer Systems, Inc.