Delta RMC151 - Manual (Page 585)

6 Communication
3. Set the Cyclic I/O Data Locations in the RMC
In the Project pane, expand the Modules folder, double-click the CPU module, and
choose EtherNet/IP.
In the Outgoing Cyclic I/O Data section, enter the starting location for the Outgoing
Cyclic I/O Data. In our example, verify that the location is the Indirect Data Map Entry
0 Value.
In the Incoming Cyclic I/O Data section, enter the starting address for the
Incoming Cyclic I/O Data. Click the Browse button and browse to the desired RMC
location for the outgoing data. This should be a location in the Indirect Data Map,
the Variable Table, or Command Area as discussed in the Determine I/O Data
Locations in the RMC section above.
For example, the EtherNet/IP Settings Page below shows an RMC150 with the
Outgoing Data coming from the Indirect Data map starting at item 0 and the
Incoming Data going to the Indirect Data starting at item 12.
deltamotion.com 565