Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1001)

Brocade Network Advisor SAN + IP User Manual 929
53-1003155-01
Layer 3 access control list policy
22
4. Select one of the following protocol options:
• TCP
• UDP
5. Enter a port number in the Port field.
6. Click OK on the Duplicate Service dialog box.
7. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 912.
Deleting a service
You can access the Service dialog box when configuring an extended L3 ACL device configuration.
To configure an extended L3 ACL, refer to one of the following procedures:
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an extended L3 ACL configuration” on page 901
• “Copying an extended L3 ACL configuration” on page 902
• “Creating an extended L3 ACL configuration” on page 899
• “Editing an IPv6 L3 ACL configuration” on page 906
• “Copying an IPv6 L3 ACL configuration” on page 907
To delete one or more services, complete the following steps.
1. Click the Services tab.
2. Select one or more services that you want to delete and click Delete.
3. Click Yes on the confirmation message.
4. Click Close on the Service dialog box.
To finish configuring the advanced settings for the ACL, refer to “Configuring L3 ACL advanced
settings” on page 912.