Removing an option from a device’s shortcut menu – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 654
582
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Removing an option from a device’s shortcut menu
12
5. Choose one of the following options:
-
To display the menu option only for devices that meet the conditions listed, select the
Match Conditions option.
-
To display the menu option on the shortcut menus for all devices, select the All option.
If you select All, skip to
. Otherwise, continue to
.
6. Change the type in the Condition 1 Property name list.
7. Change the value for the selected property in the Condition 1 Value field.
8. (Optional) Change the Condition 2 Property type or edit the Value for that property type
(Condition 1 AND Condition 2 must be true) to edit a second condition to be simultaneously
true.
NOTE
To set up a condition where Condition 1 OR Condition 2 must be true, define two menu items,
one for each condition.
9. Select the tool from the Tool list that you want to launch, or click Define to add a tool.
To specify a new tool, refer to
10. Select the Append device ID check box to specify the parameter used when opening the tool.
-
To specify that the device’s IP address should be used when opening the tool, select the IP
Address option.
-
To specify that the device’s Node WWN should be used when opening the tool, select the
Node WWN option.
11. Click Edit.
NOTE
You must click Edit before clicking OK; otherwise, your changes will be lost.
12. Click OK to save your work and close the Setup Tools dialog box.
Removing an option from a device’s shortcut menu
You can remove a tool that displays on a device’s shortcut menu.
To remove an option to the device’s shortcut menu, complete the following steps.
1. Select Tools > Setup.
The Setup Tools dialog box displays.
2. Click the Product Menu tab.
The Product Popup Menu Items table displays all configured menu options.
3. Select the menu item you want to remove in the Product Popup Menu Items table.
4. Click Remove.
5. Click OK to save your work and close the Setup Tools dialog box.