Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1060)

988 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Network connections
25
FIGURE 383 Edit Smart Card dialog box
2. Insert the smart card into the card reader.
3. After the card’s ID is displayed by the card reader in the Card ID field, enter the security
administrator password used to allow editing of the smart card, then click Login.
NOTE
The Card Password field is activated after the card ID is read, and the Login button is activated
after the password is entered in the Card Password field.
4. Edit the card as needed. Note the following:
• Card Assignment: A maximum of 64 characters is permitted for the user first and last
name to whom the card is assigned. All characters are valid in the editable columns,
including spaces.
• Notes: A maximum of 256 characters is permitted for any miscellaneous notes. Editing
these values in BNAthe Management application does not modify the information that is
stored on the card. Notes are optional.
• The Change Password check box must be selected before you can enter the new password
information. You must re-enter the new password for verification.
5. Click OK.
NOTE
You can view the status indicator at the bottom of the dialog box to determine card reader status.
Network connections
Before you use the encryption setup wizard for the first time, you must have the following required
network connections: