Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1461)

Brocade Network Advisor SAN + IP User Manual 1389
53-1003155-01
Creating a payload configuration
33
FIGURE 622 Configuration dialog box - Deployment Properties pane
8. Select one of the persistence properties.
• Don’t Save to Flash or Reload
Select this option if you just want to update the device running configuration. The payload
configuration is not saved to the device flash memory, nor is the device rebooted when the
payload configuration is deployed.
• Save to Flash
Select this option if you want to make the payload configuration permanent in the device
flash memory and saved to the running configuration. Selecting this option is the same as
entering a write memory command on the device CLI. The payload configuration is applied
to the device when the device reboots.
• Save to Flash and Reload
Select this option if you want to save the payload configuration to the device flash memory
and reboot the device. It is the same as entering the write memory and reload commands
to the device CLI.
NOTE
This option is available only to Management application users who have the “Reload
Device” privilege in their user account.