Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 2079)

Brocade Network Advisor SAN + IP User Manual 2007
53-1003155-01
MAPS actions
50
4. Click OK on the MAPS Policy Actions dialog box.
5. Click Close on the MAPS Configuration dialog box.
Configuring e-mail notification
In environments where it is critical that you are notified about errors quickly, you can use e-mail
notifications. With e-mail notifications, you can be notified of serious errors by e-mail, text
message, or pager, so you can react quickly.
1. Right-click a device in the Product List or Connectivity Map and select Fabric Vision > MAPS >
Configure.
The MAPS Configuration dialog box displays.
2. Select an object in the MAPS policies list and click E-mail Setup.
Select All Fabrics to configure e-mail notification for all policy rules for all MAPS-enabled
devices in all fabrics.
Select one or more fabrics to configure e-mail notification for all policy rules on all
MAPS-enabled devices in the selected fabrics.
Select one or more devices to configure e-mail notification for all policy rules on the selected
devices.
The MAPS E-Mail Setup dialog box displays. This dialog box enables you to configure e-mail
notification for all policy rules on a device.
3. Enter one or more addresses in the E-mail address text box.
You can enter up to 5 addresses, separated by semi-colons. E-mail addresses are logical
switch specific, not physical chassis specific. You can configure different e-mail addresses for
different logical switches in the same physical chassis.
To send a text message or page via e-mail, use the following format [email protected],
where number is your phone number and carrier.com is the SMS server. For example,
[email protected] (text message) or [email protected] (page).
NOTE
Check with your carrier for the exact e-mail address.
4. Enter the IP address of the relay host in the Relay Host field.
Relay host is a physical chassis setting. This setting affects all logical switches in the physical
chassis.
5. Enter the domain name in the Domain Name field.
Domain name is a physical chassis setting. This setting affects all logical switches in the
physical chassis.
6. Click OK on the MAPS E-Mail Setup dialog box.
7. Click Close on the MAPS Configuration dialog box.