Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1896)

1824 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Creating a custom frame monitor
45
4. Select one or more switches in the Products / Monitors list, and click the right arrow button to
assign the frame monitor to those switches.
5. Select the Port option.
6. Expand the switch in the Products / Ports list.
The Monitors list displays all of the frame monitors defined for that switch.
7. Select one or more ports.
You must select only ports belonging to the same switch.
8. Select one or more frame monitors in the Monitors list.
9. Click the right arrow button to move the frame monitor to the selected ports.
The Monitor Details list displays the monitors that are assigned to a selected port. If no
monitors are assigned, or if more than one port is selected, the Monitor Details list does not
display.
10. Click OK.
The Frame Monitor Configuration Status dialog box displays ( Figure 819 ).
FIGURE 819 Frame Monitor Configuration Status dialog box
11. Click Start.
The frame monitor configuration is applied to the switches.
12. Click Close after configuration is complete (indicated by “Completed” in the Progress column).