Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 269)

Brocade Network Advisor SAN + IP User Manual 199
53-1003155-01
Software Configuration
5
Client export port settings
You can configure a port for communication between the client and server.
Configuring the client export port
To configure client export port settings, complete the following steps.
1. Select Server > Options.
The Options dialog box displays.
2. Select Client Export Port to assign a communications port between the client and server in the
Category list.
The Client Export Port pane displays ( Figure 77 ).
FIGURE 77 Options dialog box (Client Export Port pane)
3. Enter the client export port number to set a fixed port number for the client in the Client Export
Port field.
The current port number displays in the Current Port # field.
The default port number (55555) displays in the Default Port # field.
4. Click Apply or OK to save your work.
NOTE
Changes to this option take effect after a client restart.
5. Click OK on the “changes take effect after client restart” message.
Client/Server IP
You can configure connections between the client or switches and the Management application
server.
Configuring the server IP address
If your Operating System is IPv4-enabled or IPv6-enabled (running in dual mode), the server binds
using an IPv4 address. IPv6 only mode does not support server to client communication (the IPv6
address cannot be bound to the server).
NOTE
If the Management server or client has multiple Network Interface Cards and if any of these
interfaces are not plugged in, you must disable them; otherwise, the following features do not work
properly: