Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 159)

Brocade Network Advisor SAN + IP User Manual 89
53-1003155-01
IP discovery profiles
3
NOTE
This settings cannot be disabled for DCB switches.
NOTE
Network OS devices must be running version 4.0 or later to enable this setting.
NOTE
For Network OS devices, adaptive discovery is also performed for Syslog events.
The lazy polling function sends login and log messages to the Master Log and the switch
console. If you are receiving too many messages due to lazy polling, clear the check box to
disable off lazy polling.
You cannot change the lazy polling interval for IronWare OS or Network OS devices. The
lazy polling interval is based on the size of your network. For IronWare OS devices, default
values are as follows:
• Small: 2 minutes
• Medium: 15 minutes
• Large: 30 minutes
For Network OS devices, default values are as follows:
• Small: 15 minutes
• Medium: 30 minutes
• Large: 60 minutes
e. Click Apply to save your work.
4. Click Close to close the Discover Setup - IP dialog box.
5. Click Yes on the confirmation message.
IP discovery profiles
NOTE
You cannot configure a discovery profile if you do not have the All IP Products AOR (area of
responsibility) in your user account.
A discovery profile contains the settings you configure when discovery is run. These settings
include address range parameters, ping sweep parameters, SNMP settings, default passwords,
and other settings. The Management application is shipped with a default discovery profile named
“Default”. You can create more than one discovery profile. You can select one discovery profile to
run automatically at startup. After startup, one or more profiles can be run consecutively.
NOTE
The Discovered Products table lists all products discovered through individual product discovery,
profile-based discovery, as well as Fabric discovery (from the SAN tab).