Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1653)

Brocade Network Advisor SAN + IP User Manual 1581
53-1003155-01
Chapter
41
Deployment Manager
In this chapter
• Introduction to the Deployment Manager . . . . . . . . . . . . . . . . . . . . . . . . 1581
• Editing a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1581
• Duplicating a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . 1582
• Deleting a deployment configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1583
• Deploying a configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1583
• Viewing deployment logs. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1583
• Generating a deployment report . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1583
• Generating a deployment configuration snapshot report. . . . . . . . . . . . 1584
• Searching the configuration snapshots . . . . . . . . . . . . . . . . . . . . . . . . . . 1584
Introduction to the Deployment Manager
The Deployment Manager allows you to view, edit, duplicate, delete, deploy, and generate reports
for the following types of deployment configurations:
• DCB
• VLAN
• STP
• Security
You cannot create configurations using the Deployment Manager. The deployment configurations
must have been previously created and saved. Refer to the following sections for information about
creating these types of configurations:
• “Fibre Channel over Ethernet” on page 795 (for DCB configurations)
• “VLAN Management” on page 1439 (for VLAN and STP configurations)
• “Security Management” on page 875
Deployments that were created through the legacy Configuration Wizard are listed in the
Deployment Manager dialog box, but cannot be modified, deployed, or deleted. You can only
launch reports for these deployments.
Editing a deployment configuration
1. Select Configure > Task Scheduler.
The Task Scheduler dialog box displays, as shown in Figure 724 .