Viewing switch configurations – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 710
638
Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Configuration file management
14
•
Clear the Backup all fabrics check box and select the specific fabric Backup check boxes
in the Selected Fabrics table to back up individual fabrics.
The Selected Fabrics table includes the following information:
•
Fabric Name — The world wide name of the fabric selected for backup configuration.
•
Status — The status of the fabric selected for backup configuration; for example,
unknown or marginal.
•
# of Switches — The number of switches that are configured on the fabric selected for
backup configuration.
If any switches do not have the EGM license, a messages displays. Click OK to enable
backup on the switches with the EGM license.
5. Click OK.
Click OK on the confirmation message.
Viewing switch configurations
The Switch Configurations tab of the Configuration File Manager dialog box allows you to display
the configuration for each switch or fabric, including the name of the switch, the firmware version,
and the name of the switch configuration type.
To view configurations for a switch or fabric, complete the following steps.
1. Click the SAN tab.
2. Select Configure > Configuration File > Configuration File Manager.
3. Click the Switch Configurations tab.
The Switch Configurations tab of the Configuration File Manager dialog box displays, as shown
in