Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1618)

1546 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
GSLB policy management
39
To apply policy metrics, perform the following steps.
1. Click the Metrics tab on the Policy Configuration dial box.
2. Select the order from the Metric Order list. Metric order is the order in which the GSLB
ServerIron ADX product applies the policy metrics:
• Default Order: Metrics are applied in a fixed order as defined in the GSLB ServerIron ADX
product.
• Select Order: Metrics are applied in the order specified in this parameter.
3. Select the configuration you want from the Available Configurations list, and click the right
arrow button to move it to the Selected Configurations list.
If you want to remove the configuration from the Selected Configurations list, select the
configuration, and click the left arrow button to move it back to the Available Configurations
list.
NOTE
If Select Order is selected in the Metric Order list, metrics are applied in the order they appear
in the Selected Configurations list. You can change the order of the configurations by selecting
a configuration, and clicking the Up or Down button to move it up or down in the list.
4. If Connection Load is selected in the Selected Configurations list, enter values for the following
options.
NOTE
If Host is selected as the policy type, these options are disabled.
• Limit — Enter a load limit value for the connection. The valid limit range is from 1 through
2147483647 and the default value is 5.
• Multiplier — Enter a multiplier value from 1 through 60. The default value is 5.
• Intervals — Enter an interval value from 1 through 8. The default value is 5.
• Connection Load Weights
a. Click to add a row to the Connection Load Weights list, where you can add connection
load weight values.
b. Select a row and click to delete the row from the Connection Load Weights list.
Adding a prefix on the Prefix tab
1. Click the Prefix tab on the Policy Configuration dialog box, shown in Figure 707 .
2. Click Add.
A new row is added to the Geo Prefix/Static Prefix list.