Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1385)

Brocade Network Advisor SAN + IP User Manual 1313
53-1003155-01
Deleting an Allow/Prohibit Matrix configuration
30
FIGURE 581 Activate Matrix Confirmation message
4. Select the Active=Saved check box to save the active configuration as the startup
configuration (IPL).
5. Click OK to confirm.
If you select the Active=Saved check box, the text [=Active] is appended to the IPL file in the
Configure Allow/Prohibit Matrix dialog box.
The Active=Saved check box and the IPL filename represent the current state of the
Active=Saved Mode (ASM) bit on the switch. However, this is limited to changes done to the
ASM configuration through the Management application. If changes occur through external
means (such as, Webtools or the CLI) the changes are not reflected in the Management
application until the Configure Allow/Prohibit Matrix dialog box is re-launched.
NOTE
Active=Saved” means the matrix configuration will survive a power failure. If not selected, all
ports can access each other after power is restored.
Deleting an Allow/Prohibit Matrix configuration
You cannot delete the active configuration, the IPL configuration, or a configuration that is marked
as having uncommitted changes.
1. Select Configure > Allow/Prohibit Matrix.
The Configure Allow/Prohibit Matrix dialog box displays.
2. Select the Allow/Prohibit Matrix configuration you want to delete.
You can do this by expanding the view for the switch under Available Switches and selecting a
configuration, or you can select the matrix under Allow/Prohibit Matrix.
3. Click Delete.
A confirmation message displays.
4. Click Yes to confirm.
Changing the Allow/Prohibit Matrix display
You can modify the matrix display on the Configure Allow/Prohibit Matrix dialog box using the
Window Arrangement list above the matrix display or the Clear all port names option below the
display.