Customizing the san inventory widget – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 465
Brocade Network Advisor SAN + IP User Manual
393
53-1003155-01
Status widgets
8
•
Bar chart — The product status as a percentage of the total number of products.
The bar chart displays each group as a separate bar on the graph. Displays the current state of
all products discovered for a group in various colors on each bar. Tooltips showing the number
of devices in that state are shown when you pause on the bar.
•
Color legend — Displays the color legend below the bar chart using the following color codes:
-
Green — Healthy: Status obtained from the SAN switch based on Fabric Watch or
Monitoring and Alerting Policy Suite (MAPS) thresholds configured on the switch.
-
Yellow — Marginal: Status obtained from the SAN switch based on Fabric Watch or MAPS
thresholds configured on the switch.
-
Red — Down: Status obtained from the SAN switch based on Fabric Watch or MAPS
thresholds configured on the switch.
-
Blue — Not Reachable: SAN switch is not reachable by HTTP.
-
Gray — Unknown: Temporary status that displays when switch asset collection is in
progress. Once switch asset collection is complete, the current status is obtained from the
switch.
•
Time Scope — The time scope.
Customizing the SAN Inventory widget
You can customize the SAN Inventory widget to display the product inventory for a specific group.
The group type and number of devices in the group displays to the left of the associated bar; for
example, v7.0.0 [3], where v7.0.0 is the firmware number and [3] is the number of devices running
that firmware level.
•
Change the grouping by selecting one of the following from the Group By list:
-
Firmware — The product inventory by firmware release.
-
Model — The product inventory by model.
-
Location — The product inventory by physical location.
-
Contact — The product inventory by contact name.
•
Zoom in on an area of the widget by dragging the mouse (upper left corner to lower right
corner) to select one or more bars.
NOTE
If the ratio between the longest and shortest bar reaches 5000:1, you should maximize the
widget prior to using zoom.
To return the widget to its original state, reverse the selection (drag from lower right corner to
upper left corner).
Accessing additional data from the SAN Inventory widget
Double-click a section in the SAN Inventory widget to navigate to the SAN Products - Status dialog
box (where Status is the section of the widget you selected). For more information, refer to