Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1199)

Brocade Network Advisor SAN + IP User Manual 1127
53-1003155-01
Master keys
25
FIGURE 507 Backup Master Key for Encryption Group dialog box - Backup Destination to smart cards
4. Select A Recovery Set of Smart Cards as the Backup Destination.
5. Enter the recovery card set size.
6. Insert the first blank card and wait for the card serial number to appear.
7. Run the additional cards through the reader that are needed for the set. As you read each card,
the card ID displays in the Card Serial# field. Be sure to wait for the ID to appear.
8. Enter the mandatory last name and first name of the person to whom the card is assigned.
9. Enter a Card Password.
10. Re-enter the password for verification.
11. Record and store the password in a secure location.
12. Click Write Card.
You are prompted to insert the next card, up to the number of cards specified in step 5 .
13. Repeat step 6 through step 12 for each card in the set.
14. After the last card is written, click OK in the Master Key Backup dialog box to finish the
operation.
Overview of saving a master key to a smart card set
A card reader must be attached to the SAN Management application PC to save a master key to a
recovery card. Recovery cards can only be written once to back up a single master key. Each master
key backup operation requires a new set of previously unused smart cards.