Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1472)

1400 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Product configuration templates
34
c. To enter a parameter for a CLI command, select the parameter type from the CLI
Commands list - Parameters folder and click the right arrow to move the parameter type to
the CLI Commands text area.
Parameters use the following format: $<name|data_type>, where name is the parameter
and data_type is the type of parameter.
Parameter types include integer ($<name|INTEGER>), string ($<name|STRING>),
slot/port ($<name|SLOT_PORT>), MAC address ($<name|MAC>), and IP address
($<name|IP_ADDRESS>).
d. Edit the parameter by entering the variable or character string you want to use for the
parameter in place of the name variable.
NOTE
Each parameter must be unique. The Management application does not check for
duplicate parameters.
access list 400 deny $<ip|IP_ADDRESS>
In the example,
access list 400 deny
is the CLI command,
ip
is the parameter variable
and
IP_ADDRESS
is the parameter type.
e. (Optional) Select a template from the CLI Templates folder and click the right arrow to
include it in the configuration.
This allows you to deploy more than one template to a device in a single deployment. Only
templates defined in the Management application display. The list and button only display
when there is at least one user-defined CLI template.
6. Click the Parameters tab and complete the following steps.
FIGURE 629 CLI Template dialog box - Parameters tab
a. Select the Always prompt for parameter review/edit during manual deployment check box
to display the Parameter tab in the Prompt dialog box during manual deployment.
Clear to not display the Parameter tab in the Prompt dialog box during manual
deployment. If this check box is clear and you do not fill in all parameter values, the
Prompt dialog box displays.
When selected, the Parameter tab displays in the Prompt dialog box during manual
deployment even if you filled in all parameter values on the Parameters tab of the CLI
Template dialog box.
b. Select one of the following options from the Mode list for the parameter import mode.
• Same Values for each Target — Select to set the same values for all selected targets.
• Different Values for each Target — Select to set individual values for the selected
targets.