Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 841)

Brocade Network Advisor SAN + IP User Manual 769
53-1003155-01
HCM and Management application support on ESXi systems
19
1. Click Edit on the Discover VM Managers dialog box.
The Edit VM Manager dialog box displays.
2. Enter the VMM server port number into the Port field. The valid port number range is from 0
through 65536.
3. Enter the user ID into the User ID field to identify the user of the VMM. The maximum number
of supported characters is 64.
4. Enter the password into the Password field. The maximum number of supported characters is
64.
5. Enable or disable the vSphere client plug-in registration. If you enable this plug-in, events are
forwarded from the Management application to the vCenter server.
6. Click OK.
The VMM discovery process begins. When complete, the vCenter server and all ESX and ESXi
hosts managed by that vCenter display in the Host product tree.
Deleting a VM Manager
You cannot delete an ESX host. Hosts can only be excluded or included. If you select a host from
the Discovered VM Managers list in the Discover VM Managers dialog box and click Delete, the
host displays in the Previously Discovered Addresses list.
HCM and Management application support on ESXi systems
Through the Brocade Adapters ESXi Management feature, ESXi systems support HCM and the
Management application when CIM Provider is installed on these systems.
For installation and other information on CIM Provider, refer to the following publications:
• CIM Provider for Brocade Adapters Developer’s Guide
• CIM Provider for Brocade Adapters Installation Guide
ESXi CIM listener ports
The Management application server uses two CIM indication listener ports to listen for CIM
indications.
NOTE
s Management Application does not support CIM indications for Emulex Adapters.
• HCM Proxy Service CIM Indication Listener Port — This port is used to listen for CIM indications
from ESXi hosts managed through HCM instances launched by the Management application.
You can learn the value of these ports through the Port Status dialog box.
• Fault Management CIM Indication Listener Port — This port is used to listen for CIM indications
from ESXi hosts managed through the Management application’s host adapter discovery.
The two ports described above are part of the range of ports reserved for use by the Management
application server, configurable during installation from the Server Configuration wizard. Refer to
the Installation and Migration Guide for server configuration instructions.