Adding target disk luns for encryption, Adding target disk luns for encryption 3 – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1175
Brocade Network Advisor SAN + IP User Manual
1103
53-1003155-01
Adding target disk LUNs for encryption
25
NOTE
Both the Hosts in Fabric table and the Selected Hosts table now contain a Port ID column to
display the 24-bit PID of the host port.
4. Select one or more hosts in a fabric using either of the following methods:
a. Select a maximum of 1024 hosts from the Hosts in Fabric table, then click the right arrow
to move the hosts to the Selected Hosts table. (The Port WWN column contains all target
information that displays when using the nsShow command.)
b. Manually enter world wide names in the Port WWN and Node WWN text boxes if the hosts
are not included in the table. You must fill in both the Port WWN and the Node WWN. Click
the right arrow button to move the host to the Selected Hosts table.
NOTE
The selected host and target must be in the same zone, or an error will result.
The Selected Hosts table lists the following:
•
Port WWN: The selected host port’s world wide name.
•
Node WWN: The selected host node’s world wide name.
•
Port Name: The name of the host selected to access the encryption target.
•
Port WWN text box: Type a world wide name for a host port, and click the Add to Selected
Hosts button to add to the Selected Hosts table.
•
Port ID: Displays the 24-bit port ID (PID) of the host port in both the Host Ports in Fabric
table and the Selected Hosts table.
•
VI Port WWN: The world wide name of the virtual initiator port.
•
VI Node WWN: The world wide name of the virtual initiator node.
NOTE
To remove an encryption engine from the Selected Hosts table, select the engine(s), then click
the left arrow button.
5. Click OK or Apply to apply your changes.
Adding target disk LUNs for encryption
You can add a new path to an existing disk LUN or add a new LUN and path by launching the Add
New Path wizard.
NOTE
Before you can add a target disk LUN for encryption, you must first configure the Storage Arrays. For
more information, see
Complete the following steps to add a target disk LUN:
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box.
2. Select a group, switch, or engine from the Encryption Center Devices table, then select
Group/Switch/Engine > Disk LUNs from the menu task bar.