Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1587)

Brocade Network Advisor SAN + IP User Manual 1515
53-1003155-01
VPLS Manager
37
4. The next available VCID in the VCID pool is automatically placed in the VCID field. You can
change the VCID if desired as long as it is not used in a current VLL instance.
5. Modify any of the remaining values in the instance by following the procedure presented in
“Adding or editing a VPLS instance” on page 1508.
NOTE
The device folder under Available Endpoints lists all MPLS capable devices, whether or not they are
in the All MPLS Licensed and Configured Devices group. If they are not and if adding the device
endpoints in the VPLS configuration would exceed the license limit, then you will not be able to
deploy the configurations.
Editing a VPLS instance
To edit a VPLS instance, do the following:
1. Select Configure > MPLS > VPLS.
2. Select either the Views tab or the Saved Configurations tab.
3. Select the instance you want to edit from the list of VLL instances.
4. Click the Edit button.
The Target Selection dialog box displays.
NOTE
The device folder under Available Endpoints lists all MPLS capable devices, whether or not they
are in the All MPLS Licensed and Configured Devices group. If they are not and if adding the
device endpoints in the VPLS configuration would exceed the license limit, then you will not be
able to deploy the configurations.
Deleting a VPLS instance
You can delete a VPLS configuration from a device, whether or not it is covered by your MPLS
license. Do the following.
1. Select the VPLS instance you want to delete from the VPLS list. You can select more than one
by pressing CTRL + click to select the instances.
2. Click the Delete button on the tool bar.
The VPLS Configuration box appears.
3. Review the VCIDs and names listed to make sure you want to delete those configurations.
4. Click the Configuration tab to view the list of VPLS instances to be deleted.
5. Click Save to save the configuration, or Cancel if you changed your mind.
The saved configuration appears under the Saved Configuration tab. The VPLS configuration is
deleted from the devices only if they are deployed successfully. the Management application
will resynch the devices from which the VPLS instance was deleted and remove the VPLS
configuration for those devices from its database.