Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1524)

1452 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Port VLANs
36
FIGURE 652 Add VLAN dialog box — Properties tab
2. Click the VLAN View option to view the products to which the VLANs are to be deployed, or click
the Product View option to display the VLANs that are to be deployed to that product.
3. Select the Fabric OS (FOS) VLAN, IronWare (IOS) VLAN, or Network OS (NOS) VLAN type from
the Target Context list. You must select only one VLAN type. If multiple VLAN types are
selected, the target context becomes the default and an error message displays.
4. Enter the following information:
For IOS VLAN Properties:
• Name — Displays the name of the VLAN, which is editable.
• QoS — Select a QoS level from the list.
- Select Low (None or 0) through High (7) for NetIron CES products. Select None for NetIron
CER and NetIron CES products if the product does not have VLAN priority configured.
(None applies only to NetIron CER and NetIron CES products.)
- Select Low (0) through High (7) for all other IronWare OS IP products.
• Spanning Tree — Select the type of Spanning Tree Protocol from the Spanning Tree list. The list
options include STP, RSTP, and None.
• Router Interface — If you want to add a virtual routing interface to the VLAN, enter the virtual
routing interface number in this field. You can add an IP address to the virtual routing interface
once the VLAN is deployed.
- From the Product View tab, you can configure one virtual routing interface per VLAN for
each product.
- From the VLAN View tab, you can edit virtual routing interfaces on multiple products for a
specific VLAN.
The Router Interface field is editable for products that support routing and have a router
image of the firmware installed.