Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1545)

Brocade Network Advisor SAN + IP User Manual 1473
53-1003155-01
LSP
37
Deleting an LSP admin group
You can delete an LSP admin group by taking the following steps.
1. Select Configure > MPLS > LSP.
2. Select the Admin Groups tab.
3. Select the admin group to be deleted.
4. Click the Delete button.
The Delete Admin Group Configuration dialog box of the Admin Group Configuration wizard
displays.
5. Click on a series of Next buttons to deploy.
Adding an LSP path
An LSP path is a list of router hops across an MPLS domain. Paths are configured separately from
LSPs. This allows paths to be used by any LSP that knows the path name. An LSP always has a
primary path and may have several secondary paths for redundancy.
Creating a path is not absolutely necessary when configuring an LSP. If you do not create a path,
CSPF uses the information in the TED to calculate the path.
1. Select Configure > MPLS > LSP.
2. Select the Paths tab.
3. Click the Add button.
The Path Configuration dialog box of the Path Configuration wizard displays ( Figure 664 ).
FIGURE 664 Path Configuration dialog box
4. Enter a name for the path in the Name field. A maximum of 32 ASCII characters is allowed.