Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 466)

394 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Status widgets
8
NOTE
It takes a few moments to populate newly discovered products in the SAN Products - Status dialog
box (where Status is the section of the widget you selected).
SAN Status widget
The SAN Status widget ( Figure 170 ) displays the device status as a pie chart.
If you discover a DCB switch from the SAN tab, the switch status displays in both the SAN Status
and IP Status widgets. However, if you discover a DCB switch from the IP tab, the switch status only
displays in the IP Status widget.
FIGURE 170 SAN Status widget
The SAN Status widget includes the following data:
• Severity icon/product count/widget title — The color of the worst status followed by the number
of products with that status displays before the widget title.
• Pie chart — The device status as a percentage of the total number of devices.
The pie chart displays the percentage in various colors on each slice. Tooltips showing the
number of devices in that state are shown when you pause on the slice. When there is one
status category with less than one percent of the total number of devices, the status widget
displays the number of devices in each category on each slice.
• Color legend — Displays the color legend below the bar chart using the following color codes:
- Green — Healthy
- Yellow — Marginal
- Red — Down
- Blue — Not Reachable
- Gray — Unknown
• Time Scope — The time scope.