Checking the connectivity status of remote meps, Checking the, Connectivity status of remote meps – Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 1601
Brocade Network Advisor SAN + IP User Manual
1529
53-1003155-01
802.1ag Connectivity Fault Management
37
To delete a maintenance association, complete the following steps.
1. Right-click a device and select 802.1ag CFM.
The Configure 802.1ag CFM dialog box displays.
2. Select one or more maintenance associations you want to delete in the Maintenance
Association Details table.
3. Click Delete.
A confirmation message displays with a Delete the maintenance domain? check box. Make
sure that the check box is selected.
4. Click Yes on the confirmation message.
Checking the connectivity status of remote MEPs
Use the 802.1ag CFM Connectivity dialog box to check the status of all remote maintenance end
points (MEP) for the selected MEP. You can access 802.1ag CFM from the following features:
•
VPLS Manager (requires the IP - MPLS – VLL prvilege with read-write or read-only permission)
•
VLL Manager (requires the IP - MPLS – VPLS prvilege with read-write or read-only permission)
•
VLAN Manager (requires the VLAN Manager prvilege with read-write or read-only permission)
NOTE
802.1ag CFM is only supported on IronWare Ethernet Routers devices running firmware release 5.2
or later.
NOTE
You cannot configure an 802.1ag CFM on a maintenance end point (MEP) configured with dual
tagged VLANs.
To check the status of all remote MEPs for the selected MEP, complete the following steps.
1. Choose one of the following options:
•
From the VPLS Manager dialog box, Views tab, choose one of the following options:
Select a device from the VPLS Peer Status/VPLS Name/VCID list and click 802.1ag
CFM.
Select the Peer Topology tab and right-click a device in the topology and select
802.1ag CFM.
•
From the VLL Manager dialog box, Views tab, select an instance from the VLL Instances
table and click 802.1ag CFM.
•
From the VLAN Manager dialog box - VLAN View or Product View, select a VLAN from list
and click 802.1ag CFM.
The Configure 802.1ag CFM dialog box displays.
2. Select the MEP for which you want to check the status of remote MEPs in the Maintenance End
Points (MEP) table.
3. Click Connectivity.
The 802.1ag CFM Connectivity dialog box displays.