Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1552)

1480 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
LSP
37
• Maximum Rate - Sets the maximum data rate supported for data bursts above the
mean rate.
• Maximum Burst - Sets the maximum number of bytes that can be handled at the
maximum rate.
- Use LSP for OSPF shortcuts - Enables the use of traffic engineering data carried in OSPF
extensions that contain information about the interface’s metric, bandwidth reservations,
and admin group memberships.
- Use LSP for IS-IS shortcuts - Enables you to configure the IS-IS shortcut parameters. This
setting allows you to configure the target product to send out IS-IS TE packets for all of its
MPLS-enabled interfaces.
When an MPLS-enabled product receives an IS-IS TE packet, it stores the traffic
engineering information in its Traffic Engineering database (TED). The product then uses
information in the TED when performing calculations to determine a path for an LSP.
 Level — Select a level (level1 or level2) for the LSP.
 Relative Metric — Enter a relative metric (-16777215 through 16777215) for the LSP.
 Announce check box — Select to enable announce for the LSP. The default is 10.
 Announce Metric — Only available when you select the Announce check box. Enter an
announce metric (1 through 16777215) for the LSP.
9. Select the Paths tab ( Figure 669 ).
FIGURE 669 RSVP LSP Advanced Settings Paths tab
From the Paths tab you can configure primary and secondary paths for the LSP.