Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1202)

1130 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Master keys
25
Restoring a master key from a smart card set
A card reader must be attached to the SAN Management application PC to complete this
procedure.
Use the following procedure to restore the master key from a set of smart cards.
1. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 376 on page 976.)
2. Select a group from the Encryption Center Devices table, then select Group > Security from the
menu task bar.
The Encryption Group Properties dialog box displays with the Security tab selected.
3. Select Restore Master Key as the Master Key Action.
The Restore Master Key for Encryption Group dialog box displays. (Refer to Figure 510 .)
FIGURE 510 Restore Master Key for Encryption Group dialog box - Restore from smart cards
4. Choose the active or alternate master key for restoration, as appropriate.
5. Select A Recovery Set of Smart Cards as the Restore From location.
6. Insert the recovery card containing a share of the master key that was backed up earlier, and
wait for the card serial number to appear.
7. Enter the password that was used to create the card. After five unsuccessful attempts to enter
the correct password, the card becomes locked and unusable.
8. Click Restore.
You are prompted to insert the next card, if needed.
9. Repeat step 6 through step 8 until all cards in the set have been read.
10. Click OK.