Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1449)

Brocade Network Advisor SAN + IP User Manual 1377
53-1003155-01
Configuration snapshots
32
• Snapshot Type — The type of snapshot generated. There are three types:
 Manual: Generated manually by clicking the Save Snapshot button on the Backup
Configuration Manager.
 Pre-Snapshot: Generated before the new configuration was deployed to the device.
 Post-Snapshot: Generated after the new configuration was deployed to the device.
• CLI Command — The name of the device-monitoring template from the CLI Configuration
Manager used for the pre- or post-snapshot deployment.
• Configuration list — Displays details of the snapshot.
• Find — Enter a text string and perform one of the following actions:
 Click Find Next — Searches the next matching string in the configuration.
 Click Find Previous — Searches the previous matching string in the configuration.
• Reached bottom of the page icon — Displays when there are no more entries to display.
• Highlight button — Click to highlight the text string.
• Match Case check box — Click to render the search case-sensitive.
• Repeats check box — Click to continue the search at the top when the bottom is reached.
Saving a configuration snapshot
You can select a CLI template from the Save Configuration Snapshot dialog box. The CLI template is
the product-monitoring template from the CLI Configuration Manager, used for pre- or
post-configuration snapshot deployment.
To select and retrieve a CLI template, perform the following steps.
1. Click the IP tab.
2. Select Configure > Configuration File > Configuration File Manager.
3. Click the Configuration Snapshots tab.
4. Select a product from the Group/Product list.
If no CLI product-monitoring templates exist, a message displays, prompting you to create a CLI
product-monitoring template using CLI Configuration Manager.
5. Click Save Snapshot.
The Save Configuration Snapshot dialog box displays, as shown in Figure 615 .
FIGURE 615 Save Configuration Snapshot dialog box
6. Select a product-monitoring template that was previously created through the CLI
Configuration Manager from the CLI template list.
Make sure the template you select is configured for the selected products. You cannot apply an
IronWare template to a Network OS product.