Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 509)

Brocade Network Advisor SAN + IP User Manual 437
53-1003155-01
User-defined performance monitors
8
To configure a product performance monitor, refer to “Configuring a user-defined product
performance monitor” on page 441.
Accessing additional data from top or bottom product monitors
In a Top N or Bottom N monitor, double-click a row or right-click a row and select Show Graph/Table
to navigate to the Historical Graphs/Tables dialog box for the selected measures. For more
information, refer to
“Performance Data” on page 1601.
Top or bottom port performance monitors
The top or bottom port performance monitors ( Figure 193 ) display the top or bottom number of
ports (for example, bottom 10 ports) for the selected measure in a table.
FIGURE 193 Top or bottom port performance monitor example
The top or bottom port performance monitor includes the following data:
• Threshold icon/object count/monitor title — The color associated with the threshold and
number of objects within that threshold displays next to the monitor title.
• Severity icon/monitor title — The worst severity of the data based on the error count or error
rate shown next to the monitor title.
• Port — The port affected by this monitor.
• Connected_Port_Link (where Connected_Port_Link is Connected Port, Initiator, or Target) —
Displays one of the following:
- Connected Port — The ISL or IFL port on the connected device. Click to launch the switch
port properties dialog box.
- Initiator — The initiator port on the connected device. Click to launch the device properties
dialog box.
- Target — The target port on the connected device. Click to launch the device properties
dialog box.
• Measure_Type — The percentage bar of the selected measure. Depending on the selected
measure, both the error rate (per second) and error count may display. For selected measures,
more than one Measure_Type may display (for example RX and TX).