Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1123)

Brocade Network Advisor SAN + IP User Manual 1051
53-1003155-01
Creating a new encryption group
25
FIGURE 428 Select Key Vault dialog box for DPM
1. Enter the IP address or host name for the primary key vault. If you are clustering DPM
appliances for high availability, IP load balancers are used to direct traffic to the appliances.
Use the IP address of the load balancer.
2. Enter the name of the file that holds the Primary Key Vault’s CA Key Certificate or browse to the
desired location. This file can be generated from the key vault’s administrative console.
3. If you are implementing encryption on data replication LUNs used by the EMC Symmetrix
Remote Data Facility (SRDF), you must select Enabled for REPL Support.
4. Click Next.
The Specify Certificate Signing Request File Name dialog box displays. (Refer to Figure 429 .)