Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1464)

1392 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Duplicating a payload configuration
33
Duplicating a payload configuration
You can create a payload configuration by copying an existing configuration.
1. Select Configure > Configuration Wizard.
2. Select a configuration from the Product Configurations list.
3. Click Duplicate.
The Copy Configuration dialog box displays.
4. Enter a name for the new payload configuration. If you do not enter a name, the Management
application assigns the name “XXX copy”, where XXX is the name of the original configuration.
5. Click OK to close the dialog box.
You can then use the Edit button to make changes to the payload configuration.
Modifying a payload configuration
You can add payloads to a configuration, delete payloads from a configuration, and modify existing
payloads in a configuration.
You can also change the deployment targets, properties, and schedule.
1. Select Configure > Configuration Wizard.
2. Select a configuration from the Product Configurations list.
3. Click Edit.
The Select Payload pane displays. The payloads that currently exist in the configuration are
checked.
On the left side of the wizard, the Steps area displays the existing payloads and the
deployment items you can change (targets, properties, schedule), as shown in
Figure 625 on
page 1393.