Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 316)

244 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Areas of responsibility
6
FIGURE 94 Users dialog box - Users tab
3. Enter a name of the AOR in the Name field.
4. (Optional) Enter a short description for the AOR in the Description field.
5. Assign or remove products as needed.
For step-by-step instructions, refer to “Assigning products to an AOR” on page 245 or
“Removing products from an AOR” on page 247.
6. Click OK to save the new AOR and close the Add AOR dialog box.
The new AOR displays in the AOR list of the Users dialog box.
7. Click Close to close the Users dialog box.
Editing an AOR
NOTE
You cannot edit system AORs.
To make changes to an existing AOR, complete the following steps.
1. Select Server > Users.
The Users dialog box displays.
2. Select the AOR you want to edit in the AOR table and click Edit.
The Edit AOR dialog box displays.
3. Complete step 3 through step 5 in “Creating an AOR” on page 243.
4. Click OK to save the AOR and close the Edit AOR dialog box.