Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1265)

Brocade Network Advisor SAN + IP User Manual 1193
53-1003155-01
LSAN zones
26
Figure 533 shows an example in which Server 1, which is connected to a switch in the VCS fabric,
has access to local storage and to RAID storage on a Fabric OS fabric.
FIGURE 533 LSAN zoning
Supported configurations for LSAN zoning
LSAN zoning is available only for backbone fabrics and any directly connected edge fabrics. A
backbone fabric is a fabric that contains an FC router. All discovered backbone fabrics have the
prefix LSAN_ in their fabric name, which is listed in the Zoning Scope list.
LSAN zones are supported between the following types of fabrics:
• Fabric OS and Fabric OS
• Fabric OS and Network OS
NOTE
You cannot access a target on a Network OS fabric from a server on the Fabric OS fabric.
NOTE
LSAN zoning is supported only in Enterprise and Professional Plus editions.
Configuring LSAN zoning
The following procedure provides an overview of the steps you must perform to configure LSAN
zoning.
1. Select a backbone fabric from the Connectivity Map or Product List.
2. Select Configure > Zoning > LSAN Zoning (Device Sharing).
The Zoning dialog box displays, with the LSAN scope.
3. Click the Zone DB tab if that tab is not automatically displayed.
VCS fabric
FC router
Fabric OS fabric
Server 1
Storage 1
LSAN zone
RAID