Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1465)

Brocade Network Advisor SAN + IP User Manual 1393
53-1003155-01
Modifying a payload configuration
33
FIGURE 625 Configuration dialog box - Select Payload pane for editing a configuration
4. Add or remove payloads in the configuration.
• To add a payload to the configuration, select either Product Payloads or Interface
Payloads, and then select the payload you want to add.
• To remove a payload from the configuration, clear the check box of the payload.
Note that a configuration must have at least one payload. You cannot save a configuration
unless it has at least one payload.
5. Modify what needs to be changed in the Select Payload, Deployment Targets, Deployment
Properties, and other panes.
• Click Next to navigate sequentially through the panes.
• Click an item in the Steps area to jump directly to the appropriate section.
• Click Save at any time to save your changes and return to the Configuration Wizard dialog
box.
Refer to the steps in “Creating a payload configuration” on page 1385 for additional
information.