Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1486)

1414 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Monitoring configurations
34
Monitoring configurations
You can create, modify, duplicate, and delete a monitoring configuration from the CLI Configuration
dialog box. Monitoring configurations allow you to create device reports by entering a set of show
CLI commands. To view a list of existing configurations, refer to
“Viewing existing templates” on
page 1396. For information about the example templates, refer to “CLI Templates” on page 2221.
Creating a monitoring configuration
To create a new monitoring configuration, complete the following steps.
1. Select Configure > CLI Configuration.
The CLI Configuration dialog box displays.
2. Click Add.
The CLI Template dialog box displays.
FIGURE 632 CLI Template dialog box - Definition tab
3. Click the Definition tab and complete the following steps.
a. Enter a name and description for the new configuration.
NOTE
Do not use special characters in the name.
b. Select Monitoring to create product reports using show commands.
c. To change CLI credentials, click Change Template Credentials and refer to “Changing
product credentials” on page 1402.