Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1927)

Brocade Network Advisor SAN + IP User Manual 1855
53-1003155-01
PoE thresholds
46
Updating a PoE threshold
To update a PoE threshold, complete the following steps.
1. Select Monitor > Power Center.
The Power Center dialog box displays.
2. Select a product in the PoE Product list and click Thresholds.
The Thresholds dialog box displays with the thresholds defined for that product.
3. Select the threshold you want to edit in the All Thresholds list.
The selected threshold displays in the Thresholds Editor area.
4. Select the Enabled check box to enable the threshold on the product.
5. Choose one of the following measures:
• Port allocation
• Port consumption
• Port consumption %
6. Select one of the following from the Conditions list:
• >
• <
• ==
7. Enter the number of events that must be generated to trigger the threshold event in the Value
field.
The value should not exceed the capacity of the product.
If you select a percentage measure, the value should be less than or equal to 100.
8. Select the severity level for the threshold event from the Severity list.
• Info
• Warning
• Critical
9. Select the time period to be monitored for the number of threshold events in the Interval (min)
list.
The time period starts with the first event and runs its full duration if the event limit is not
reached. Interval values, in minutes, include:
• 15
• 30
• 60
10. Click Update.
The updated threshold displays in the All Thresholds list.
11. Click Close to close the Thresholds dialog box.