Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 627)

Brocade Network Advisor SAN + IP User Manual 555
53-1003155-01
Editing a Call Home center
11
Editing a Call Home center
To edit a Call Home center, select from the following procedures:
• Editing the IBM Call Home center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 555
• Editing an e-mail Call Home center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 556
• Editing the EMC Call Home center . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 560
• Editing the HP LAN Call Home center. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 561
Editing the IBM Call Home center
To edit the IBM Call Home center, complete the following steps.
1. Select Monitor > Event Notification > Call Home.
The Call Home dialog box displays.
2. Select IBM in the Call Home Centers list.
3. Click Edit Centers (beneath the Call Home Centers list).
The Configure Call Home Center dialog box displays ( Figure 235 ).
FIGURE 235 Configure Call Home Center dialog box (IBM option)
4. Make sure the Call Home center type you selected displays in the Call Home Centers list.
If the Call Home center type is incorrect, select the correct type from the list.
5. Select the Enable check box to enable this Call Home center.
6. Set the time interval at which to check the Call Home center by selecting the Set heartbeat
interval at ___ days (1-28) check box and entering the interval in the field.
7. Enter how long you want to wait before timing out the heartbeat interval in the Time Out field.
The default is 60 seconds.