Brocade Network Advisor SAN + IP User Manual v12.3.0 User Manual
Page 871
Brocade Network Advisor SAN + IP User Manual
799
53-1003155-01
Saving running configurations
20
FIGURE 311
Save Running to Startup dialog box
2. Highlight a discovered DCB switch from the Available Switches list, and click the right arrow
button to move the switch to the Selected Switches list.
3. Highlight the selected switch and click OK to start the configuration.
The running configuration is saved to the selected switch, effective on the next system startup.
If you restore the DCB switch using the Restore Switch Configuration dialog box, you are
prompted to select one of two restoration methods:
•
As the running configuration and reboot
ATTENTION
Rebooting a switch connected to a fabric will stop all traffic to and from the switch. All ports
on the switch will become inactive until the switch comes back online.
•
As the startup configuration (no reboot)
For instructions on how to restore a saved switch configuration, refer to the section
in the “Device Configuration” chapter.