Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1743)

Brocade Network Advisor SAN + IP User Manual 1671
53-1003155-01
IP historical performance monitoring
43
19. Click Next on the MIB Index dialog box.
The Threshold & Rearm dialog box displays.
FIGURE 754 Data Collector wizard Threshold & Rearm dialog box
This Threshold & Rearm dialog box allows you to establish a a threshold value that triggers a
trap message when the threshold is met, and to establish conditions for repeating threshold
check and trap messages.
20. Select the Enable threshold and rearm events check box to enable the Threshold and Rearm
selectors.
21. Select the Fixed Threshold value and assign a Threshold Trap Severity level.
22. Select the Fixed Rearm value and assign a Rearm Trap Severity level. If the Fixed Rearm value
is the exact value used to trigger rearming (repeating the threshold check and trap message),
select Absolute. If the Fixed Rearm value is expressed as a percentage of the threshold value,
select Percent of threshold.
23. Click Finish to accept your entries.