Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1463)

Brocade Network Advisor SAN + IP User Manual 1391
53-1003155-01
Creating a payload configuration
33
12. Select Save Without Scheduling Deployment or Schedule Deployment.
If you select Schedule Deployment, select the frequency, time, and date parameters for the
deployment.
13. Click Next.
The Summary Page pane displays, as shown in Figure 624 .
FIGURE 624 Configuration dialog box - Summary Page pane
14. Review the information on the Summary Page pane.
• The Deployment and Targets tab shows the deployment definition and the targets in the
configuration. The Selected Targets list allows you to verify to which devices the payloads
in the configuration are deployed.
• The Configuration tab summarizes the payloads in the configuration you have created.
If you must make changes, click Previous to return to a previous pane, or click another pane in
the Steps area on the left side of this pane.
15. Click Save or Deploy. The availability of the Save and Deploy buttons depends on what you
selected on the Deployment Properties pane.
• Save appears if you selected Save configuration. The saved configuration then appears in
the Product Configurations list in the Configuration Wizard dialog box.
• Deploy appears if you selected One-time deployment, do not save configuration. If you
click Deploy, the Deployment Status dialog box displays. If you want to view the
configuration deployment status at another time, select Reports > Deployment.