Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 165)

Brocade Network Advisor SAN + IP User Manual 95
53-1003155-01
IP discovery profiles
3
1. Select CIDR Subnet from the Entry Type list.
FIGURE 30 Exclude CIDR Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask bits in the Subnet Mask Bits field.
For IPv4, the subnet mask bits is between 0 and 32.
For IPv6, the subnet mask bits is between 0 and 128.
4. To include an address range using the CIDR Subnet format, refer to “Adding CIDR subnet
addresses” on page 93.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 92.
Excluding subnet addresses
To exclude subnet addresses (IPv4 only), complete the following steps.
1. Select Subnet from the Entry Type list.
FIGURE 31 Exclude Subnet
2. Enter the IP address in the IP Address field.
3. Enter the subnet mask in the Subnet Mask field.
4. To include an address range using the Subnet format, refer to “Adding subnet addresses” on
page 93.
5. To finish configuring the address ranges, return to “Configuring address ranges” on page 92.