Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1926)

1854 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
PoE thresholds
46
7. Select the time period to be monitored for the number of threshold events in the Interval (min)
list.
The time period starts with the first event and runs its full duration if the event limit is not
reached. Interval values, in minutes, include:
• 15
• 30
• 60
8. Click Add.
The new threshold displays in the All Thresholds list.
9. Select the Enabled check box of the new threshold in the All Thresholds list to enable the
threshold on the product.
10. Click Close to close the Thresholds dialog box.
11. Click Refresh on the Power Center dialog box to determine if any thresholds are triggered.
12. Click Close to close the Power Center dialog box.
Viewing PoE thresholds
To view PoE thresholds, complete the following steps.
1. Select Monitor > Power Center.
The Power Center dialog box displays.
2. Select a product in the PoE Product list and click Thresholds.
The Thresholds dialog box displays with the thresholds defined for that product.
3. Review the following information in the All Threshold list.
• Enabled check box — Checked when the threshold is enabled. Clear when the threshold is
disabled.
• Product — The Product for which the threshold is configured.
• Port — The Port for which the threshold is configured.
• Measure — The power measure on which you defined the threshold condition.
• Condition — The condition you defined for the threshold.
• Value — The value you defined for the threshold.
• Severity — The severity you defined for the threshold.
• Interval (min) — The time period in minutes you defined for the threshold.
• Enabled Threshold — The number of enabled thresholds.
4. Select a threshold in the All Threshold list to review the following information in the Selected
Threshold Events list.
• Time — The date and time that the event was triggered.
• Event Value — The value of the triggered event.
5. Click Close to close the Thresholds dialog box.
6. Click Close to close the Power Center dialog box.