Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 150)

80 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Default IP user credentials
3
5. Enter an enable prompt user name and password by selecting Read/Write Enable Prompt from
the Credential Type list and completing the following steps.
FIGURE 22 Read/Write Enable Prompt
a. Enter a unique label to identify the credentials in the Display Label field.
This label can be from 1 through 200 characters long, case sensitive, and allows all
printable ASCII characters.
b. Enter the user name in the User ID field.
c. Enter the user password in the Password field.
d. Click the right arrow button.
e. If the devices use multiple user names and passwords, use the Up or Down buttons to
place the most commonly used at the top of the Enable Prompt list to make discovery run
more efficiently.
6. Enter a super user password by selecting Enable Super User from the Credential Type list and
completing the following steps.
FIGURE 23 Enable Super User
a. Enter a unique label to identify the credentials in the Display Label field.
This label can be from 1 through 200 characters long, case sensitive, and allows all
printable ASCII characters.
b. Enter the super user password in the Password field.
c. Click the right arrow button.
d. If the devices use multiple user names and passwords, use the Up or Down buttons to
place the most commonly used at the top of the Enable Super User list to make discovery
run more efficiently.
7. Click Apply to save your work.