Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1184)

1112 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Adding target tape LUNs for encryption
25
FIGURE 495 Encryption Target Tape LUNs dialog box
4. Click Add.
The Add Encryption Target Tape LUNs dialog box displays. (Refer to Figure 496 .) A table of all
LUNs in the storage device that are visible to hosts is displayed. LUNs are identified by the Host
world wide name, LUN number, Volume Label Prefix number, and Enable Write Early ACK and
Enable Read Ahead status. The LUN numbers may be different for different hosts.
FIGURE 496 Add Encryption Target Tape LUNs dialog box
5. Select a host from the Host list.
Before you encrypt a LUN, you must select a host, then either discover LUNs that are visible to
the virtual initiator representing the selected host, or enter a range of LUN numbers to be
configured for the selected host.