Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1118)

1046 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Creating a new encryption group
25
2. Select a switch from the <NO GROUP DEFINED> encryption group. (The switch must not be
assigned to an encryption group.)
3. Select Encryption > Create/Add to Group, from the menu task bar.
The Configure Switch Encryption wizard welcome screen displays. (Refer to Figure 424 .) The
wizard enables you to create a new encryption group, or add an encryption switch to an existing
encryption group. The wizard also enables you to configure switch encryption.
Click Next on each screen to advance to the next step in the wizard. Steps might vary slightly
depending on the key vault type selected, but the basic wizard steps are as follows.
a. Designate Switch Membership.
b. Create a new encryption group or add a switch to an existing encryption group.
c. Select the key vault.
d. Specify the public key filename.
e. Select Security Settings.
f. Confirm the configuration.
g. Configuration Status.
h. Read Instructions.
FIGURE 424 Configure Switch Encryption wizard - welcome screen
4. From the Configure Switch Encryption welcome screen, click Next to begin.
The Designate Switch Membership dialog box displays ( Figure 425 ). The dialog box contains
the following options:
• Create a new encryption group containing just the switch: Creates an encryption group for
the selected switch
• Add this switch to an existing encryption group: Adds the selected switch to an encryption
group that already exists