Brocade Network Advisor SAN + IP User Manual v12.3.0 - Manual (Page 1482)

1410 Brocade Network Advisor SAN + IP User Manual
53-1003155-01
Valid and invalid responses from devices
34
Editing the Motorola Controller CLI responses properties file
The MotorolaControllerCliResponse.properties file is under the Install_Home\conf\cli directory.
Edit the file using a text editor.
You can add a success response between the SUCCESS_RESPONSE_START and
SUCCESS_RESPONSE_END tags using the following Unicode regular expressions format.
#Success Map
SUCCESS_RESPONSE_START
^su[port]*\s+s[witchd]*\s+=.*First Failure Data Capture.*enabled.*
^n[o]\s+su[port]*\s+s[witchd]*\s+=.*First Failure Data Capture.*disabled.*
^f[fdc]*=.*First Failure Data Capture.*enabled.*
^n[o]\sf[fdc]*=.*First Failure Data Capture.*disabled.*
SUCCESS_RESPONSE_END
You can add a failure response between the FAILURE_RESPONSE_START and
FAILURE_RESPONSE_END tags using the following Unicode regular expressions format.
#Failure Map
FAILURE_RESPONSE_START
^nt[p]*\s+s[erv]*\s+=.*too many.*
^sn[mp\-serv]*\s+h[ost]*\s+=.*Maximum number of hosts in this version group
reached.*
^sn[mp\-serv]*\s+u[ser]*\s+=.*Maximum limit of users in this access group
reached.*no
^sn[mp\-serv]*\s+=.*too many.*
FAILURE_RESPONSE_END
The strings on the left and the right side of the equal sign are Unicode regular expressions used for
pattern matching. The expression on the left is matched against the command string, while the
expression on the right is matched against the messages returned by the command that matches
the pattern on the left. For details on the supported Unicode regular expression syntax, refer to
“Regular Expressions” on page 2215.
The new response is available to the Management application as soon as you save the file; you do
not need to restart the Management application.
Configuration command response validation
Command responses are only validated for configuration deployments. Validation occurs in the
following order:
1. Failure Map — Checks the response message against the regex defined in the failure map. If a
match is found, it is treated as failure response from the device and stops the validation
process.
2. Success Map — Checks the response message against the regex defined in the success map.
If a match is found, it is treated as a success response from the device and stops the validation
process.
3. General Failure Strings — Checks the response message against the general failure strings. If a
match is found, it is treated as a failure response from the device and stops the validation
process.